Cable sheath

There are a wide array of different cable sheath types, but not all substances make suitable cable jackets for certain types of use. The following materials are typically used for cable inner (bedding) and outer sheaths : Thermoplastic. Thermoplastic compounds are materials that go soft when heated and harden when cooled: PVC (Polyvinyl Chloride) – as a sheath material, PVC is used extensively because of its low cost and good . Veel vertaalde voorbeeldzinnen bevatten cable sheath – Engels-Nederlands woordenboek en zoekmachine voor een miljard Engelse vertalingen.

Thermoplastic-sheathed cable (TPS) consists of an outer toughened sheath of polyvinyl chloride (PVC) (the thermoplastic element) covering one or more individual cables which are PVC insulated annealed copper conductors.

It is a commonly used type of wiring for residential and light commercial construction in many . Commonly known as a Megger Test, it uses a Megohmmeter to measure the resistance of the cross-linked or thermoplastic compound to an applied DC voltage. It should be noted that this test is designed to demonstrate the integrity . Simply put, its the outer covering of the cable. When you hold the cable , the rubber-like material that you feel is the sheath.

It is used to protect the inner conductors, and also to prevent electrocution! Many translated example sentences containing cable sheath – Russian-English dictionary and search engine for Russian translations.

Voorbeeldzinnen met ` cable sheath `. Staat je antwoord er niet bij of heb je een vraag waarbij het vertaalwoordenboek geen hulp kan bieden? The all round pinpointing receiver. Cable sheath fault location. High voltage bridge for fault location in long cables.

Sheath fault location system. The sheath test system MMG is used for the voltage testing of plastic insulated cable jackets. Single conductor cables present certain application considerations that do not arise in multiconductor cable installations. These considerations apply to both single con- ductor mineral insulated copper sheath cables and polymer insulated cables having an aluminum or copper armor or sheath.

When sizing cables , the heat generated by losses within any sheath or armour need to be evaluated. When significant, it becomes a factor to be considered in the sizing of cables. A close-fitting tubular covering that protects a cable. In fact, when it comes to data or LAN cabling, most will ultimately look at the cable performance when deciding on whether to install CAT5E, CATor . German-English Dictionary: Translation for cable sheath.

A mechanically sound and strong connection is essential.

When cable sheaths are bonded together, the induced voltages are short circuited but a current flows in the closed loop and this gives rise to heat loss. An aluminum electrical cable produced by the conform process can be seen in Fig. If a single-core- cable sheath is earthed at both ends of the cable, any induced voltage causes a circulating current around the earth loop, resulting in the generation of heat, which may require derating of the cable in terms of current- carrying capacity. Clean the cable and remove of the outer cable sheath and shield if present.

Remove the aramid and fiber yams to the ring cut. Cut strength member from the ring cut. Strip away any insulation present on the strength member all the way back to the ring cut. If a shield is present in the cable, tab the . The combination of paper and the air space between the conductor and the paper provides the needed insulation.

Some of the older cables in . Points that require particular attention about the sheath of the fiber cable are as follows. The fiber must be kept free from microbend loss increase. Product name, Dimensions, Weight, Applicable cable diameter. HS cable sheath cutter – Type S, ×110×160mm, 800g, ø15~31mm . Used to strip cable sheaths from cables of various diameters.

It is able to make both longitudinal and circumferential cuts. The rotating cutting head allows a change of direction of the cut without the need to remove the tool from cable. The tool is also suitable for removing polymeric insulation .